MSR ELECTRONIC Intec Controls PolyGard 2 GC-06 Series - Relay Status of the Signal Relays - Signal Relay Addr. 1-96, Modbus Register Addr. 7001-7096; Relay Status of the Alarm Relays - Alarm Relay Addr. 1-32, Modbus Register Addr. 8001-8032; Error Codes, Modbus Register Addresses 9000-9104

3.9 Relay status of the signal relays – signal relay addr. 1–96, Modbus register addr. 7001–7096
3.10 Relay status of the alarm relays – alarm relay addr. 1–32, Modbus register addr. 8001–8032
Figure 7: Relay status of the alarm relays – alarm relay addr. 1–32, Modbus register addr. 8001–8032
The relay status of the controller’s fault message relay is in register 8000.
The following values are possible:
• -1: Relay is not active
• 0: Relay is active, not energized
• 1: Relay is active, energized
3.11 Error codes, Modbus register addresses 9000–9104
Figure 8: Error codes, Modbus register addresses 9000–9104
INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com
Specifications subject to change without notice. | GA_GC06_Modbus_supplement_E, 2022-04-05 | USA 221209 | Page 9 of 12
DGC6 Modbus Supplement – UserManual