EasyManuals Logo

MTD 340 Series User Manual

MTD 340 Series
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
SECTION7: TROUBLESHOOTINGGUIDE
Possible Cause(s)
Fuel tank empty, or stale fuel.
Trouble
Engine fails to
start
Engine runs
erratic
Engine over-
heats
Tines do not
engage
Throttle control lever not in correct
starting position (if equipped).
Blocked fuel line.
Dirty aircleaner.
Choke not in ON position (if equipped).
Spark plug wire disconnected.
Faulty spark plug.
Engine flooded.
Unit running on CHOKE (if equipped).
Spark plug wire loose.
Blocked fuel line or stale fuel.
Vent in gas cap plugged.
Water or dirt in fuel system.
Dirty air cleaner.
Carburetor out of adjustment.
Engine oil level low.
Dirty air cleaner.
Air flow restricted.
Carburetor not adjusted properly.
Foreign object lodged in tines.
Tine clevis pin(s) missing.
Pulley and idler not in correct
adjustment.
Control cable not adjusted properly.
Belt worn and/or stretched.
Corrective Action
Fill tank with clean, fresh gasoline. Fuel will not last over
thirty days unless a fuel stabilizer is used.
Move throttle lever to start position.
Clean fuel line.
Refer to the engine manual packed with your unit.
Move switch to ON position.
Connect wire to spark plug.
Clean, adjust gap or replace.
Refer to the engine manual packed with your unit.
Move choke lever to OFF position.
Connect and tighten spark plug wire.
Clean fuel line; fill tank with clean, fresh gasoline. Fuel will
not last over thirty days unless a fuel stabilizer is used.
Clear vent.
Drain fuel tank. Refill with fresh fuel.
Refer to the engine manual packed with your unit.
Refer to the engine manual packed with your unit.
Fill crankcase with proper oil.
Refer to the engine manual packed with your unit.
Refer to the engine manual packed with your unit.
Adjust carburetor as instructed in separate engine manual.
Dislodge foreign object.
Replace tine clevis pin(s).
Take unit to authorized service dealer.
Adjust control cable (see assembly instructions).
Replace belt.
14

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MTD 340 Series and is the answer not in the manual?

MTD 340 Series Specifications

General IconGeneral
BrandMTD
Model340 Series
CategoryTiller
LanguageEnglish

Related product manuals