MTD 820 Series User Manual

N
IV. SERVICE
1. Use extra care in handling gasoline and other fuels. They are
flammable and vapors are explosive.
a. Use only an approved container.
b. Never remove gas cap or add fuel with the engine running.
Allow engine to cool at least two minutes before refueling.
Do not smoke.
c. Never refuel the machine indoors.
d. Never store the machine or fuel container inside where
there is an open flame, or spark, such as a water heater,
space heater, clothes dryer and the like.
2. Never run a machine inside a closed area.
3. Check frequently and keep nuts and bolts, especially blade
attachment bolts, tight and keep equipment in safe working
condition.
4. Never tamper with safety devices. Check their proper operation
regularly. Use all guards as instructed in this manual,
5. To reduce fire hazard, keep machine free of grass, leaves or
other debris build-up. Clean up oil or fuel spillage. Allow
machine to cool before storing.
6. Stop and inspect the equipment for damage if you strike an
object. Repair, if necessary, before re-starting and operating
the machine.
7. Never make adjustments or repairs with the engine running.
8. Grass catcher components are subject to wear, damage and
deteriorate, which could expose moving parts or allow objects
to be thrown. Frequently, check components and replace with
manufacturer’s recommended parts when necessary.
9. Mower blades are sharp and can cut. Wrap the blade(s) or
wear gloves and use extra caution when servicing blade(s).
10. Check brake operation frequently. Adjust and service as
required.
11. Muffler, engine, and belt guards become hot during operation
and can cause a burn. Allow to cool down before touching.
12. Do not change the engine governor settings or overspeed the
engine.
A Your unit was built to be operated according to the rules for safe operation in this manual. As with any type
DANGER: of power equipment, carelessness or error on the part of the operator can result in serious injury. If you vio¬
late any of these rules, you may cause serious injury to yourself or others.
ASSEMBLY INSTRUCTIONS
This owner’s manual covers various models of
tractors. The units illustrated may vary slightly
from your unit. Follow the instructions which per¬
tain to your unit.
IMPORTANT: After assembly, service engine with
gasoline, and check oil level as instructed in the
separate engine manual. Do not overfill.
Self-Tapping
Screws
Seat
Pivot
Bracket
FIGURE 1.
NOTE: Reference to right or left hand side of the
unit is observed from the driver’s seat, facing for¬
ward. Refer to the separate deck manual for all
information regarding the deck.
UNPACKING
1. Remove the carton from the tractor as follows.
Open the top flaps and remove all carton inserts.
Carefully cut on dotted line all the way around the
carton. Lift the carton off the tractor. Remove the
deck from beneath the tractor. Roll the tractor off
the skid. Make certain all parts and literature have
been removed from the carton before the carton
is discarded.
2. Remove page four from this manual and lay the
contents of the hardware pack according to the
illustration for identification.
SEAT ASSEMBLY
Remove the four hex self-tapping screws from the
bottom of the seat. Place the seat in position against
the seat pivot bracket, lining up the slotted holes in
the pivot bracket with the holes in the seat. Select
desired position for the seat, and secure with hex self¬
tapping screws. See figure 1.
A
BATTERY INFORMATION
WARNING
A. Battery acid must be handled with great care as
contact with it can burn and blister the skin. It is
also advisable to wear protective clothing (gog¬
gles, rubber gloves and apron) when working with
it.*
B. Should battery acid accidentally splatter into the
eyes or onto the face, rinse the affected area
immediately with clean, cold water. If there is any
further discomfort, seek prompt medical attention.
C. If acid spills on clothing, first dilute it with clean
water, then neutralize with a solution of ammonia/
water or baking soda/water.
D. Since battery acid is corrosive, do not pour it into
any sink or drain. Before discarding empty elec¬
trolyte containers, rinse them with a neutralizing
solution.
E. NEVER connect or disconnect charger clips to bat¬
tery while charger is turned on as it can cause
sparks.
F. Keep all lighted materials (cigarettes, matches,
lighters) away from the battery as the hydrogen
gas generated during charging can be com¬
bustible.
G. As a further precaution, only charge the battery in
a well-ventilated area.
‘Always shield eyes, protect skin and clothing
when working near batteries.
5

MTD 820 Series Specifications

General

Brand	MTD
Model	820 Series
Category	Tractor
Language	English