18
We suggest wearing:
#
safety helmet
#
noise-damping earplugs
#
protective goggles or visor
#
protective gloves
#
protective trousers
#
sturdy shoes not sliding
Always use an extension cable with
high insulation characteristics and
which meets all current legislation
requirements.
# When operating a power tool outdoors,
use an extension cord suitable for
outdoor use.
Use of a cord suitable for outdoor use reduces
the risk of electric shock.
#
Before starting the motor, ensure that the
extension cable is clear of the cutting zone.
#
Any damaged cable must be replaced
immediately by authorized staff.
#
Remove the plug from the sacket before
carrying out any adjustment, servicing or
maintenance.
#
For safety reasons, the socket used to power
the unit should be backed up by a residual
current device-operated (FI) circuitbreaker
which can be tripped by a max. current of
30mA.
#
Check damaged parts. Before further use
of your chainsaw, a guard or other part that is
damaged should be carefully checked to
determine whether it will operate properly and
perform its intended function. Check for
alignment of moving parts, binding of moving
parts, breakage of parts, mounting and any
other conditions that may affect its operation.
A guard or other part that is damaged should
be properly repaired or replaced by an
ENGLISH
authorised service agent. Do not use your
chainsaw if the switch does not turn it on and
off.
5. ELECTRICAL SAFETY
# Voltage:
make sure your machine is correct
for your mains supply
# Current:
your machine is suitable for AC
supply only.
# Plugs/extension leads:
we recommend
the use of PVC or rubber covered plugs,
connectors and leads with your machine.
# Power point:
the machine must be
connected to a power point and not a lighting
socket.
N
FIG. 1
The package contains the following
items:
1.
Rear handle
2.
Lock off safety button
3.
Start lever
4.
Chain oil tank
5.
Bar with toothed pinion
6.
Chain
7.
Front handle
8.
Air intakes
9.
Power supply cable with plug
10.
Brake-hand guard engaging lever
11.
Chain guard
12.
Bar locking hand wheel + chain tension
adjustment hand wheel
13.
Bar locking pin
14.
Chain pinion
NOTE:
make sure that the power tool and
accessories in the package are not damaged
NOTE:
read these operative instructions
carefully before attempting to operate the drill
To Next Page
Loading...
