25
Troubleshooting
EN
Troubleshooting
WARNING!
Risk of injuries or material damage
¾ In case of doubt always consult a specialist workshop.
¾ Before any inspection or any work on the device, switch off the motor and remove the power
pack.
Problem Possible cause Remedy
The device switch-
es off.
The power pack is too hot. Allow the power pack to cool.
The power pack is discharged. Charge the power pack.
The temperature of the device (electronics) is too
high.
Allow the device too cool and if neces-
sary, clean the air inlet.
Overcurrent release If this occurs again take your device to a
specialist workshop.
The device will not
switch on.
The power pack is discharged. Charge the power pack.
Overcurrent release If this occurs again take your device to a
specialist workshop.
Power pack temperature too high or too low. Allow the power pack to cool down or
warm up.
The power pack is defective. Replace the power pack.
Vibrations. The vacuum/blow turbine is heavily soiled. Clean the vacuum/blow turbine.
Strong vibrations Damaged blowing turbine or other parts. Switch off the device immediately.
Have defective parts replaced by a
workshop.
The motor has no
power or the device
is not vacuuming/
blowing.
The vacuum bag is full. Empty the vacuum bag.
The vacuum/blow pipe is blocked. Remove and clean the vacuum/blow
pipe.
The vacuum/blow turbine is damaged. Have defective parts replaced by a
workshop.
Warranty
The warranty conditions of our local company or importer apply in all countries. Under the terms of the war-
ranty we will repair faults on your device free of charge, insofar as material or manufacturing defects are the
cause. To make a claim under warranty please contact your seller or your nearest branch.
CE Declaration of Conformity
Further details about the device are contained on the separately enclosed CE Declaration of
Conformity, which forms part of this instruction manual.
Environmentally-friendly disposal
Electrical tools, accessories and packaging must be routed into an environmentally compatible recycling
chain.
Power packs/batteries:
Do not dispose of power packs/batteries in domestic waste, by burning or throwing into water.
Power packs/batteries must be collected, recycled or disposed of in an environmentally friendly
manner.
Power tools:
Do not throw your power tool away with domestic waste! Take it to an appropriate disposal facility.
To Next Page
Loading...
