MTF DM2 600i - Replacing the Blades

85

REPLACINGTHEBLADES

1.Switchthemowerof
2.Wearprotectivegloves
3.Turnthemowerupside‐down.
4.Useanotherscrewdrivertoholdthebladewhen
replacingtheblades.
5.UseaPhillipscrewdrivertoremovethecutting
blade.
6.Placebladeoverraisedscrew‐hole.
7.Use
aPhillipsscrewdrivertosecurethecutting
bladetotheblade.Thecuttingblademustrotate
freely.
8.Repeatthesameprocedurefortheothercutting
blades.


Re‐orientatetheblade(turnitaroundorturnit
upsidedown)aseachcornerwearsoutuntilall
fourquartersof
thebladehavebeenused.Ifall
fourquartershavebeenused,thenreplaceblade.
Carrythemowerbythehandlebetweenthetwo
rearwheelswiththebladespointingoutwards.
