MTU 12V 2000 G63 - Cylinder-Head Cover - Removal and Installation

Valve Gear 6–13
6.4.2 Cylinder-head cover – Removal and installation
Preconditions
• Engine is stopped and starting disabled.
Special tools
Designation / Use Part No. Qty.
Torque wrench
Spare parts
Designation / Use Part No. Qty.
Gasket
Preparatory steps
1. On cylinder-head covers with crankcase breather: Loosen clamps.
2. Slide rubber sleeves onto the pipe.
Cylinder-head cover – Removal and installation
1. Remove screws.
2. Remove cylinder-head cover with gasket from
cylinder head.
3. Clean mating faces.
4. Check condition of gasket in cylinder-head cover.
5. Replace damaged gasket(s).
6. Pl
ace cylinder-head covers onto crankcase and
tighten screws to 20 Nm.
Final steps
1. Slide rubber sleeves onto the relevant pipe connection.
2. Tighten all clamps.
M015560/00E 03-05 ©MTU