6–56 Battery-Charging Generator
6.17.3 Battery-charging generator drive – Drive belt replacement
Preconditions
• Engine is stopped and starting disabled.
Spare parts
Designation / Use Part No. Qty.
Ribbed belt
Battery-charging generator drive – Drive belt
replacement
1. Remove guard cover.
2. Remove ventilator drive belt (applicable only to
TD cooling). (→ Page 6 – 60)
3. Loosen securing screws (2 and 3).
4. Release tensioning screw (1) until the ribbed
belt can be removed.
5. Check belt pulleys for cleanliness, remove
dirt, if any.
6. Fit new drive belt.
7. Tension drive belt with tensioning nut (1) and
check belt tension (→ Page 6 – 53).
8. Tight
en securing screw (2).
• Tightening torque: 40 Nm +4 Nm
9. Tighten securing screw (3).
10. Install ve
ntilator drive belt (→ Page 6 – 60)
11. Install guard cover.
M015560/00E 03-05 ©MTU
To Next Page