What to do if there is coolant discharge at intercooler of MTU 12V4000G34F?
If you notice coolant discharge at the intercooler of your MTU Engine, and it seems like a major coolant discharge due to leaking, contact service.
General| Engine Model | 12V4000G34F |
|---|---|
| Engine Type | Diesel |
| Configuration | V12 |
| Speed | 1800 rpm |
| Bore | 170 mm |
| Compression Ratio | 16.5:1 |
| Aspiration | Turbocharged and Intercooled |
| Cooling System | Liquid Cooled |
| Emission Standards | IMO Tier II |
General safety instructions and nameplate information for all products.
Requirements for operational environment, residual hazards, hot surfaces, and noise.
Specifies requirements for personnel qualification and protective equipment.
Safety measures for initial startup, operation, and emergency stops.
Safety procedures for assembly, maintenance, repair, lifting, and cleaning.
Guidelines for fire prevention, noise, environmental protection, and handling fluids.
Description of the fuel system and its low and high-pressure components.
Description of the lube oil system, including pumps, filters, and heat exchangers.
Overview of the high-temperature and low-temperature coolant circuits.
Explanation of the engine monitoring system and the ECU 9 governor.
Procedure for bringing the engine back into operation after long periods of inactivity.
Procedure for starting the engine in manual mode for test runs.
Instructions for safely restarting the engine after an automatic shutdown.
Description of the override function for safety systems and emergency starts.
Guidelines for monitoring engine operation and key parameters.
Procedure for starting the engine in emergency situations using override mode.
Procedure for stopping the engine in manual mode after a test run.
Procedure for performing an emergency engine stop.
Table listing maintenance tasks, items, options, and page references.
Guides for diagnosing and resolving engine issues.
Lists fault messages and corrective actions for the ADEC ECU 9.
Procedure for performing an engine test run.
Procedure for filling the HP fuel pump with engine oil.
General instructions for injector replacement.
Detailed steps for removing and installing injectors.
Procedure for replacing injector rings.
Procedure for replacing the fuel filter.
Procedure for replacing the additional fuel filter.
General instructions for replacing fuel prefilter elements.
Procedure for replacing the filter element of a switchable fuel prefilter.
Procedure for replacing the filter element of a non-switchable fuel prefilter.
Procedure for removing and installing a new air filter.
Procedure for changing the engine oil, including draining and filling.
Specifications for tightening torques of various screws, nuts, and bolts.
To Next Page
