MTU 16V 2000 M72 - Lube Oil System, Lube Oil Circuit

7.13 Lube Oil System, Lube Oil Circuit
7.13.1 Engine oil – Level check
Preconditions
☑ Engine is stopped and starting disabled.
Oil level check prior to engine start
1. Withdraw oil dipstick from guide tube and
wipe it.
2. Insert oil dipstick into guide tube up to the
stop, withdraw after approx. 10 seconds
and check oil level.
3. Oil level must be between "min." and "max."
marks.
4. Top up to "max." if required (→ Page 103).
5. Insert oil dipstick into guide tube up to the
stop.
Oil level check after the engine is stopped
1. 5 minutes after stopping the engine, remove oil dipstick from the guide tube and wipe it.
2. Insert oil dipstick into guide tube up to the stop, withdraw after approx. 10 seconds and check oil level.
3. Oil level must be between “min.” and "max." marks.
4. Top up to "max." if required (→ Page 103).
5. Insert oil dipstick into guide tube up to the stop.
102 | Task Description | M015650/03E 2011-10
TIM-ID: 0000000032 - 002