Abbre-
viation
Meaning Explanation
KS Engine driving end Engine driving end in accordance with DIN ISO 1204
LCD Liquid Crystal Display, Liquid Crystal Device
LCU Local Control Unit LOP subassembly
LED Light Emitting Diode
LMU Local Monitoring Unit LOP subassembly
LO Low Alarm: Measured value lower than 1st minimum limit
value
LOLO Low Low Alarm: Measured value lower than 2nd minimum lim-
it value
LOP Local Operating Panel Control console, control panel
LOS Local Operating Station
LPU Lubricating Oil Pump Control Unit Lube oil pump control
MCS Monitoring and Control System
MG Message
MPU Microprocessor Unit, Microprocessing Unit
TDC Top Dead Center
P-xyz Pressure-xyz Pressure measuring point xyz
PAN Panel Control panel
PAU Power Automation Unit Module for monitoring, control and plant-related sys-
tem integration of peripheral components
PCU Propeller Control Unit
PIM Peripheral Interface Module
UPS Unit Pump System
POM Power Output Module Module to control starter and battery-charging gen-
erator
PPC Priming Pump Control Oil priming pump
RCS Remote Control System
RL Redundancy Lost Alarm: Redundant CAN bus failure
SAE Society of Automotive Engineers U.S. standardization organization
SD Sensor Defect Alarm: Sensor failure
SDAF Shut Down Air Flaps Emergency-air shutoff flap(s)
SS Safety System Safety system alarm
SSK Emergency-air shutoff flap(s)
T-xyz Temperature-xyz Temperature measuring point xyz
TD Transmitter Deviation Alarm: Sensor comparison fault
BDC Bottom Dead Center
VS Voith Schneider Voith Schneider drive
WJ Water jet Water jet drive
TC Tool Catalog
150 | Appendix A | MS150094/02E 2015-05
TIM-ID: 0000002045 - 019
To Next Page
Loading...
