MTU 16V2000S56 - Cylinder Head Cover - Removal and Installation

6.3.2 Cylinder head cover – Removal and installation
Preconditions
☑ Engine is stopped and starting disabled.
Special tools, Material, Spare parts
Designation / Use Part No. Qty.
Torque wrench, 8–40 Nm
F30043446 1
Ratchet
F30027340 1
Gasket
(→ Spare Parts Catalog)
Preparatory steps
1. On cylinder head covers with crankcase breather: Loosen clamps.
2. Slide rubber sleeves onto the pipe.
Cylinder head cover – Removal
and installation
1. Remove cylinder head cover (2) with gas-
ket (1) from cylinder head.
2. Clean installation surface.
3. Check condition of gasket (1) in cylinder
head cover (1).
4. Replace damaged gasket(s) (1).
5. Install cylinder head cover (2) with screws (4)
and washers (3).
Final steps
1. Slide rubber sleeves onto the relevant fitting.
2. Tighten all clamps.
80 | Task Description | MS150094/02E 2015-05
TIM-ID: 0000000019 - 005