What should I do if the charge-air temperature at sensor B9 has exceeded limit value 2 in my MTU Engine?
If the charge-air temperature at sensor B9 exceeds limit value 2, reduce power. Contact Service.
What should I do if the lube oil pressure at sensor B5.1 has fallen below limit value 1 in my MTU Engine?
If the lube oil pressure at sensor B5.1 falls below limit value 1, check the engine oil level. Contact Service.
What should I do if the lube oil pressure at sensor B5.1 has fallen below limit value 2 in my MTU Engine?
If the lube oil pressure at sensor B5.1 falls below limit value 2, check the engine oil level. Contact Service.
What to do if the coolant level at switch F33 is too low in MTU Engine?
If the coolant level at switch F33 is too low, check the engine coolant level, check the relief bore of charge-air coolant pump, and visually inspect the coolant circuit for leaks. Contact Service.
What should I do if the differential oil pressure at sensors B5.1 and B5.3 has exceeded limit value 1 on my MTU Engine?
If the differential oil pressure at sensors B5.1 and B5.3 exceeds limit value 1, replace the engine oil filter. Contact Service.
What should I do if the differential oil pressure at sensors B5.1 and B5.3 has exceeded limit value 2 on my MTU Engine?
If the differential oil pressure at sensors B5.1 and B5.3 exceeds limit value 2, replace the engine oil filter. Contact Service.
What does it mean if switch F46 in the collection tank has tripped in my MTU Engine?
If switch F46 in the collection tank has tripped, it indicates a leak has occurred in the HP fuel system. Contact Service.
What to do if the engine speed has exceeded the limit value or the engine overspeed test has been tripped in MTU Engine?
If an emergency stop has been tripped by the engine overspeed test, restart the engine. If an emergency stop has been tripped by the engine, contact Service.
What should I do if the turbocharger speed at sensor B44 has exceeded limit value 1 in my MTU Engine?
If the turbocharger speed at sensor B44 exceeds limit value 1, reduce power. Contact Service.
What should I do if the lube oil temperature at sensor B7 has exceeded limit value 1 in my MTU Engine?
If the lube oil temperature at sensor B7 exceeds limit value 1, reduce power, check the operation of the cooler and fan (plant side), and check the engine coolant level. Contact Service.
General safety information and intended use of the product.
Safety rules to follow before and during engine startup and operation.
Safety guidelines for performing maintenance and repair tasks on the engine.
Guidelines for fire safety, environmental protection, and handling of fluids and lubricants.
Detailed description of the engine's systems and components.
Visual overview of the engine with labeled components.
Identification and function of key sensors and actuators on the engine.
Technical specifications for various engine models and configurations.
Provides the overall physical dimensions of the engine.
Procedures for starting and stopping the engine, including manual trials.
How to perform an emergency stop and post-stop procedures.
Routine checks to perform during engine operation.
Reference table linking tasks to maintenance schedule entries.
Guide to diagnosing and resolving common engine problems.
Lists fault messages from the engine governor and their corrective actions.
Information related to SOLAS requirements and installation of shielding.
Tasks related to engine barring, test runs, and component maintenance.
Step-by-step guide to replacing the engine's fuel filter.
Detailed procedure for replacing the engine oil filter.
Procedures for checking, changing, draining, and filling engine coolant.
Inspection and replacement procedures for the engine's belt drive system.
Checks for engine cabling, wiring, and engine governor connections.
Glossary of abbreviations used throughout the manual.
List of special tools required for maintenance and repair tasks.
To Next Page
General