Need help?Do you have a question about the MTX Thunder TC4002 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| THD at Rated Power | <0.05% |
| Signal to Noise Ratio | > 100 dB |
| Frequency Response | 10 Hz - 30 kHz |
| Crossover Frequency | 50 Hz - 250 Hz |
| Fuse Rating | 30A |
| Input Sensitivity | 200 mV - 4 V |
| RMS Power at 4 Ohms | 100 Watts |
| RMS Power at 2 Ohms | 200 Watts |
| Bridged RMS Power at 4 Ohms | 400 Watts |
Detailed instructions for establishing the primary power connection to the amplifier.
Procedure for wiring the remote turn-on circuit for amplifier operation.
Essential steps for creating a secure and effective ground connection.
Guidance on the installation and function of the remote gain control unit.
Explanation of how to connect audio input signals using RCA or high-level inputs.
Final steps for completing the installation by reconnecting the battery ground.
How to choose between high-pass, low-pass, and full-range filter modes.
Instructions for setting the crossover point between 40Hz and 350Hz.
Details on using the bass boost feature to enhance low-frequency response.
Steps to diagnose and resolve no-power issues for the amplifier.
Troubleshooting steps for when the amplifier is on but produces no sound.
Guidance for resolving intermittent amplifier operation or shutdowns.
Steps to identify and fix problems causing audio loss on one channel.
Troubleshooting low overall audio volume from various sources.
Resolving amplifier shutdowns potentially caused by heat or voltage.
Diagnosing intermittent amplifier operation due to voltage fluctuations.
Methods to eliminate noise issues, such as ground loops or RCA interference.
To Next Page
