Need help?Do you have a question about the MTX thunder X504 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| RMS Power @ 4 Ohms | 50W x 4 |
| RMS Power @ 2 Ohms | 75W x 4 |
| Bridged RMS Power @ 4 Ohms | 150W x 2 |
| Frequency Response | 20Hz - 20kHz |
| Signal to Noise Ratio | >95dB |
| Crossover Type | Variable High-Pass/Low-Pass |
Details CEA2006 certified power output for 4-ohm, 2-ohm, and bridged configurations.
Lists variable high pass, band pass, and low pass crossover frequencies.
Covers Signal-to-Noise Ratio, THD+Noise, and Frequency Response.
Details maximum input signal, sensitivity, dimensions, and high-level input.
Describes RCA input jacks for front and rear channels and required signal level.
Explains using speaker level inputs and the need for a remote turn-on wire.
Details the function of the gain control for matching input sensitivity.
Explains the high pass x-over switch and frequency control adjustments.
Explains the low pass x-over switch and frequency control adjustments.
Details how to create a band pass x-over using high and low pass controls.
Advises on speaker polarity and minimum load recommendations.
Explains ATC type fuses and the need for an additional fuse near the battery.
Describes power, remote turn-on, and ground terminal connections.
Details disconnecting battery, determining mount location, and running cables.
Explains installing a fuse, connecting power cable, and securing ground wire.
Guides connecting remote turn-on, RCA/speaker level inputs, and speaker terminals.
Advises on double-checking connections and setting the gain level.
Step-by-step guide to adjusting amplifier gain for optimal output.
Lists common problems like no LED, no output, distorted audio, and their solutions.
To Next Page
