INSTALLING A KILL SWITCH
Locate the Kill switch on a suitable position on the steering handle or somewhere on the
boat near the operator’s position, and run a twin flex wire to the engine.
Follow the diagram for wiring the actual switch from the enclosed Kill Switch instructions.
Connect one wire to the same bolt you used as the ‘ground’ for the black battery wire.
Connect the other wire to the joining two wires #3 and #11. You may snip off the
connectors of #3 & #11 and add the Kill Switch wire to them, using a wire nut. Alternatively,
find another male plug and add #3 and the Kill wire together and crimp the plug onto both.
Then plug into #11.
Run the engine and test the switch.
Kill switches are designed to be used. Make sure you do!
To Next Page
Loading...