Due to EPA regulations, there is no fuel/air
mix adjustment on these engines as the
carburetor is preset.
Recoil start:
Hold the starter handle and pull it slightly
until the compression position is reached,
and then pull it swiftly from this position;
Slowly return the starter handle to its original
position after the engine
starts.
Electric start;
·Turn the key switch to "START" position;
and keep it there until the engine starts.
If engine does not start after running the
electric starter for 5 sec, wait 10 sec before trying
again.
After engine starts, release the key switch, it will
return to "ON"(or "RUN") position.
After engine starts, gradually turn the choke lever to
the full "OPEN" position, and set the throttle lever in
the Max. position. Before placing under load, warm up
the engine
for about 3
min.
To switch off,
turn the fuel
cock off first,
then use the
on/off switch.
Don’t switch
off the engine under load at high speed. It could cause damage.
To Next Page
Loading...