Mueller B-100 - User Manual

MUELLER
®
opERating instRUctions ManUaL
Customer Service Center
Decatur, Illinois
800.423.1323
www.muellercompany.com
moreinfo@muellercompany.com
All warranties, expressed or implied, for Mueller Drilling Machines are
rendered null and void if the machines are used with shell cutters or
equipment manufactured by someone other than Mueller Co.
WARNING:
1. Read and follow instructions carefully. Proper training and periodic
review regarding the use of this equipment is essential to prevent possible
serious injury and/or property damage. The instructions contained herein
were developed for using this equipment on ttings manufactured by
Mueller Co. only, and may not be applicable for any other use.
2. Do not exceed the pressure ratings of any components or equipment.
Exceeding the rated pressure may result in serious injury and/or property
damage.
3. Safety goggles and other appropriate protective gear should be used.
Failure to do so could result in serious injury.
4. Pressure test, check for and repair leaks in all ttings and components
each time one is installed or any joint or connection is broken. Failure
to nd and repair a leak from any source in the ttings, bypass lines or
equipment could result in an explosion and subsequent serious injury
and/or property damage.
5. Mueller
®
Drilling Machines and Equipment have been carefully designed
and engineered to work together as a unit. The use of equipment manu-
factured by someone other than Mueller Co. may cause excessive wear or
a malfunction of the Mueller machines.
!
Reliable Connections
TM
B-101
TM
and B-100
TM
Drilling and
Tapping
Machine
TABLE OF CONTENTS PAGE
General Information 2-3
Maintenance Instructions 3-4
Operating Instructions 5-11
Parts Information 12
Removal and Replacement of
Boring Bar Bearing 13
Notes 14-15

Summary

General Information

Capacity and Use

Details the machine's drilling and tapping capabilities and its mechanism for preventing drill spiraling.

Maintenance Instructions

Before Use Maintenance

Operating Instructions

Select Equipment for Operation

Attach Machine to Pipe

Step-by-step instructions for securing the machine to the pipe using the saddle and chain.

Attach Tool to Boring Bar

Drill and Tap - Hand Operated Method

Detailed steps for performing drilling and tapping operations using manual control.

Drill and Tap - Power Operated Method

Instructions for drilling and tapping using electric, air, or hydraulic power operators.

Remove Tool from Main

Attach Stop or Plug to Boring Bar

Insert Stop or Plug

Procedure for inserting the stop or plug into the tapped hole in the main.

Extracting Stop or Plug Installed Under Pressure

Instructions for safely removing an installed stop or plug from a pressurized main.

Removal and Replacement of Boring Bar Bearing

To Remove the Bearing

To Replace the Bearing

Mueller B-100 Specifications

General

Brand	Mueller
Model	B-100
Category	Drill
Language	English