M0160.docx | Rev 1.3 | Modified on 19/05/2020 | © Remote Control Technologies Pty Ltd
General Safety Warnings
Personal Safety
■ Everyone is responsible for safety.
■ The installer/service personnel should be trained and authorized to complete the required work.
■ Ensure that the machine is safely isolated during installation and testing to protect all personnel.
■ Complete all required risk assessments and job safety analysis (JSA) before commencing work.
■ Observe all site-specific and machine OEM procedures regarding the following:
– working at heights
– working in heat
– working in confined spaces
– all other site-specific occupational health and safety (OH&S) procedures
Machine
■ Carry out all pre-start operations as per site and machine OEM procedures.
■ Ensure the machine is safely isolated during installation and testing to protect the machine and other
equipment in the area.
■ Do not operate any machine with a known fault and report all findings to the supervisor in writing.
■ Test and operate machine as per machine OEM and site procedures.
■ Read and understand machine and site-specific operational and testing instructions.
Product
Before applying power to the equipment, the user/repairer/installer must read all product instructions. If in
doubt, seek assistance.
■ Ensure electrical connections are made as per RCT’s recommendations. Test circuits prior to connecting
power to any part.
■ The equipment has no user-serviceable parts inside. Return the unit to RCT for repairs.
■ Retain product and installation instructions for future use.
■ Ensure that RCT’s recommended service procedures are included in the machine’s service routine.
■ Observe all machine, site and RCT product warnings.
■ Follow all machine, site and RCT product operating procedures at all time.
The application of safety should not be limited to the above recommendations.
To Next Page
Loading...
