34
35
Adjusting the brake lever grip
width
The distance between the handlebar
grip and brake lever can be adjusted. To
reduce the grip width, turn the hexagon
socket screw on the brake lever coun-
terclockwise. To increase the grip width,
turn the screw clockwise.
Note that adjusting the grip width may
require an adjustment of the brake pad
spacing. For more information, see the
„Brake system“ section.
It must not be possible to pull the brake lever through to
the handlebar. The brake must engage clearly before this.
Observe the torque specications for handlebar, stem and
stem adapter
Setting the lights
The rear light is xed to rigid bracket and does not need to be adjusted. The
front light, on the other hand, can still be tilted up and down on its bracket. Ad-
just the light so that the light cone hits the ground in the range 5-8 meters in front
of the front wheel.
Make sure that the lamp is never tilted so that it shines
upwards. This could blind oncoming road users. Falls and
serious accidents can be the result.
Adapting the e-muli to the rider
To Next Page
Loading...