muli ST+PX - Adapting the E-Muli to the Rider

28
29
After all the adjustments described below, perform 
functional test of the wheel. Follow the instructions in the
„Before each ride“ section. After the adjustments have
been made, test ride your e-muli in  place free of trac.
The e-muli is only available in one
frame size. The top tube sits so low
that  very comfortable entry is pos-
sible and the standover height usually
provides enough freedom of move-
ment for all adult riders.
Adjusting the seat height
You can nd out the optimum seat
height as follows: sit on the saddle
and place one leg with the heel on
the pedal. The pedal should be in the
lowest position for this. The saddle
should be adjusted so that the leg is
fully extended in this position.
Vi the quick release on the saddle clamp, the saddle
can be very easily adjusted in height. Open the quick
release and set the desired seat height.
Make sure that you do not pull the seat post out of the
seat tube beyond the „MIN/MAX“ mark.
Make sure that the seat
post is not too deep in
the seat tube. With some
seat posts, the tube ta-
pers at the upper end
and can no longer be
clamped securely there.
Adapting the e-muli to the rider