100
101
Lighting system
A functioning light system is mandatory for participation in public road trac.
The e-muli has either two battery-powered lights or two dynamo lights from
Busch & Müller. Furthermore, red rear light with integrated Z-reflector and
white front light with integrated reflector and two yellow reflectors per pedal
and ring reflectors on the sides of the tires. Thus, the lighting system is StVZO
compliant.
The battery light can be charged using standard USB cell phone charging cable
and do not require special charger.
Make sure that the accumulators or batteries of both lights are always charged/
full when you ride your e-muli. It is best to switch on the light at the onset of
dusk - this will make you more visible to other road users and prevent accidents.
Make sure that the rear light is always
clearly visible
The front light is xed, but it can be
tilted up and down, which allows you
to adjust the angle of light. For opti-
mum visibility, adjust the light so that
the light cone hits the ground in the
range 5-8 meters in front of the front
wheel.
Adjustment screw
Make sure that all screws on the lamp are well xed and that it does not adjust
while driving.
Keep in mind that the bulbs in the lamps wear out and must be replaced when
they fail to function.
Never ride without functioning light system. Especially
driving in the dark with non-functioning light system is
life-threatening.
Make sure your lighting system is clean and all reflec-
tors are clearly visible.
To Next Page
Loading...