80
81
Adjust bearing clearance
To adjust the bearing clearance of the handlebar, please make sure that the
quick release is tightened and the screw underneath is tightened to the specied
10 NM. Then tighten the lower clamping ring with the specied 3 NM.
Information on this also on:
https://www.youtube.com/watch?v=immIUxp0GTA
Over-tightening the stem bolts can damage the steering
tube stem and cause it to break. Observe the torque
specications on the component.
Only in the uppermost position the handlebars can be
turned in and back again. Forcibly turning the hand-
lebars when they are not in the highest position can
cause the stem adapter to bend and break.
Handlebar and stem
To Next Page
Loading...