EasyManua.ls Logo

Multi-Mover XL35 - Coupling Trailer(S); Chapter 6 MAINTENANCE; Inspection; 6.2 Lubrication and Maintenance Diagram

Default Icon
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MULTI-MOVER XL35 16
sparks.
When disassembling the batteries, first disconnect the mass cable (-)
When assembling, connect the mass cable as last.
Caution! Always plus ( + = red) to plus and minus (- = black) to minus
Battery fluid is a corrosive acid, avoid contact with clothing, skin and eyes.
Immediately wash off possible splashes on clothes or skin with water and soap, then rinse off with
plenty of water. Possible splashes of acid in the eyes, rinse with clean water for at least 5 minutes
and immediately consult a doctor.
When the battery is replaced, the old battery should be returned to your dealer or handed in at a
legally recognized collection point for batteries.
5.5 Coupling trailer(s) #
The Multi-Mover XL35 is made with a standard tow eye with tow pin or a ball coupling point in the
middle of the Multi-Mover XL35, to which the pole of a trailer can be coupled.
Maximum slope angle, with / without load 4 / 20 %
Slowly reverse the Multi-Mover XL35 to the pole of the trailer and place the tow eye or coupling of
the pole between the tow eyes or coupling point of the Multi-Mover XL35 and insert the tow pin.
Then secure the tow pin with a spring clip.
Only use the Multi-Mover XL35 if you have thoroughly studied the previous pages and you have no
more questions.
6 MAINTENANCE
When performing maintenance, you should always observe the safety regulations, (chapter 3).
During maintenance, always switch off the Multi-Mover XL35 and remove the ignition key from the
ignition lock
In case of doubt, consult the user manual.
6.1 Inspection
The operator should perform the following inspections regularly, without trailer;
- it must be possible to rotate the steering handle (swivel wheel) smoothly to the left and
right, without jolts
- keep an eye on the wear of driven (air) tyres, if the wheels slip in case of sudden brakes, they
will have to be replaced
- when accelerating quietly, it must be possible to reach the maximum speed
If one of the above tests is not satisfactory, you must immediately report this to person who is
directly responsible for the maintenance of the Multi-Mover XL35.
6.2 Lubrication and maintenance diagram
d = daily w = weekly m = monthly a = annually m = maintenance r = replacement

Related product manuals