Multi PSI Multi-160 - User Manual

Questions and Answers

R
Rebecca PetersAug 12, 2025
Why is there little or no material flow from my Multi PSI Insect Control Equipment?
- U
  ugreeneAug 12, 2025
  There could be several reasons for little to no material flow. The nozzle or suction tube might be clogged and need cleaning. The material volume setting may be too far to the right; try turning it to the left. The suction tube could be loose; ensure it is properly inserted. The material might be too thick, so check its viscosity. Finally, the container might be loose; tighten it.
R
Robert BoothAug 16, 2025
What to do if my Multi PSI Insect Control Equipment is leaking material?
- S
  Samuel DavisAug 16, 2025
  If your equipment is leaking, check the following: the nozzle may be loose and needs tightening, or the nozzle or nozzle seal may be worn and require replacement. Also, there might be material build-up on the spray pattern dial and nozzle, so ensure these are clean.
H
Heather PayneAug 19, 2025
Why is the atomization too coarse with my Multi PSI Insect Control Equipment?
- S
  Steven WilliamsAug 20, 2025
  Coarse atomization can occur if the material's viscosity is too high; try thinning it. The material volume may be too large; turn it to the right. The nozzle could be clogged and require cleaning, or there might be too little pressure build-up in the container; tighten the container.
H
Henry WatsonAug 23, 2025
What to do if the spray jet pulsates on my Multi PSI Insect Control Equipment?
- E
  Evan AndersonAug 23, 2025
  A pulsating spray jet can be caused by two things: the material in the container might be running out, in which case you should refill it, or the material could be too thick, so check its viscosity.
K
Kimberly JonesAug 27, 2025
How to fix pattern runs or sags with Multi PSI Insect Control Equipment?
- J
  Jennifer NguyenAug 27, 2025
  Pattern runs or sags usually happen because too much material is being applied. To correct this, adjust the material flow or increase the movement speed of the spray gun.
M
melissa15Aug 31, 2025
How to reduce over-spray with Multi PSI Insect Control Equipment?
- K
  Karla ReidAug 31, 2025
  Too much over-spray can be reduced by ensuring the gun is not too far from the spray object; reduce the distance. Also, if too much material is being applied, turn the material volume setting to the right.
L
latasha94Sep 4, 2025
Why is the spray pattern very light and splotchy with Multi PSI Insect Control Equipment?
- C
  Connie SmithSep 4, 2025
  A light and splotchy spray pattern is often due to moving the spray gun too fast. Adjust the material flow or decrease the movement of the spray gun to resolve this.
J
jennifergardnerSep 7, 2025
What causes a large cloud of material when using Multi PSI Insect Control Equipment?
- A
  Ashley ReeseSep 7, 2025
  A large cloud of material typically occurs if the gun is too close to the surface. Move the gun away from the surface and reduce the material flow.