[3]
When measuring capacitance, for the 60.00mF range, the measuring duration should
be over 30 seconds.
[4]
When measuring frequency, the typical waveform is Square or Sine. The signal meets
the following conditions.
[5]
When measuring duty cycle, the typical waveform is Square.
Note: when measuring resistance and capacitance, the influence of the resistance reactance of
the pen itself on the measured value should be considered.
Sample rate for digital data
√(The " " is displayed when the battery is under the proper
operation range.)
Operating: 3,000 meters
Non-operating: 15,000 meters
To Next Page
