Page <2> V1.012/10/22
Newark.com/multicomp-pro
Farnell.com/multicomp-pro
sg.element14.com/b/multicomp-pro
1. Overview
The MP760607&MP760608 are portable 1rue RMS AC/DC clamp meters with automatic range. They are designed according to
EN61010-1 CAT II 600V/CAT Ill 300V safely standards, and come with full-function protection which ensures users a safe and
reliable measurement experience. Aside from basic measurement functions. They also have high precision current scale and
high voltage frequency measurement extension.
2. Features
• True RMS measurement
• Audio visual NCV electric eld detection
• High voltage frequency range: 10Hz-60kHz; low voltage frequency range: 60Hz-10MHz
• UT203R AC/DC current range: 40A, 400A, frequency response: 45Hz-400Hz
• UT204R AC/DC current range: 60A, 600A, frequency response: 45Hz-400Hz, live/neutral wire detection
• ACA/DCA mode memory function for current measurement
• Large capacitance (MP760607: 40mF, MP760608: 60mF) and temperature measurement ( MP760606)
• Large LCD and fast refresh rate (3 times/s), capacitance measurement response time: 1mF: less than 3s; ≤10mF: about
6s; ≤60mF: about 8s
• Full-function false detecting protection for up to 600V (3.6kVA) energy surge; over voltage and over current alarm
• The power consumption without backlight is about 1.8mA. The circuit has an automatic power saving function. The con-
sumption in sleep state is <11µA, which eectively extends the battery life to 400 hours.
Please read the safety and warning parts In this manual thoroughly.
Caution: Please read the safety instructions carefully before use.
3. Standard Accessories
Open the package and check the below items, if any is missing or damaged, please contact your supplier immediately:
User manual 1 pc
Test leads 1 pair
K-type temperature probe 1 pc (Only MP760608)
Cloth bag 1 pc
4. Safety Instructions
WARNING
To ensure safe operation and service of the tester, follow these instructions. Failure to observe these warnings can result in
severe injury or death.
The meter is designed according to EN61010-1, 61010-2-032/033 and electromagnetic radiation protection EN61326-1 safely
standards, and conforms to double Insulation, CAT II 600V, CAT Ill 300V and pollution grade II. In case the meter is not used
property as instructions, the protection provided may be weakened or lost.
• Before each use verify tester operation by measuring a known voltage.
• Before use, please check if there is any item which is damaged or behaving abnormally. If any abnormal item (such as
bare test lead, damaged meter casing, broken LCD, etc.) is found, or if the meter is considered lo be malfunctioning,
please do not use the meter.
• Do not use the meter If the rear cover or the battery cover Is not covered up, or it will pose a shock hazard!
• Keep ngers behind the nger guards and away from the metal probe contacts when making measurements.
• The function switch should be placed in the correct position before measurement. It is forbidden to change the position
during measurement lo avoid damage lo the meter.
• Do not apply voltage over 600V between any meter terminal and earth ground to prevent electric shock or damage to the meter.
• Use caution when working with voltages above AC 30Vr.m.s, 42Vpeak or DC 60V. Such voltages pose a shock hazard.
To Next Page
Loading...
Need help?
General
