Page <3> V1.012/10/22
Newark.com/multicomp-pro
Farnell.com/multicomp-pro
sg.element14.com/b/multicomp-pro
• Never Input voltage or current which exceeds the specied limit. Maximum range should be selected if measured value is
unknown. Before measuring resistance, diode and continuity, please disconnect all power and fully discharge all capacitors
to avoid inaccuracy.
• When the “ ” symbol appears on the LCD, please replace the batteries in time to ensure measurement accuracy. Batteries
should be removed If the meter is long-term idle.
• Do not change the internal circuit of the meter to avoid damage to the meter and user!
• Do not expose the meter in high temperature/humidity, ammable, explosive or intense magnetic environments.
• Clean the meter casing with a soft cloth and mild detergent Do not use abrasives or solvents!
5. Symbols
Symbol Description
Caution, possibility of electric shock
Alternating currant
Direct current
Equipment protected throughout by DOUBLE INSULATION or REINFORCED INSULATION
Earth (ground) TERMINAL
Warning or Caution
Conforms to UL STD 61010-1, 61010-2.032, 61010-2.033,
Certied lo CSA STD C22.2 No. 61010-1, 61010-2-032, 61010-2.033.
It is applicable lo test and measuring circuits connected directly to utilization points (socket
outlets and similar points) of the low-voltage MAINS Installation.
It is applicable to test and measuring circuits connected lo the distribution part of the build-
ing’ s low-voltage MAINS installation.
6. General Specications
• Max LCD display counts: 4099 (MP760607), 6099 ( MP760608)
• Polarity display: Aulo
• Overload display: “OL” or”- OL”
• Low battery Indication: “ “ means low battery
• Low battery shutdown prompt The “Lo.bf” interface appears on LCD and lasts for about 10s, the buzzer beeps 3 times,
and the meter automatically shuts down.
• Test position error: If the source under test is not placed at the centre of the clamp jaws when measuring current, ±1% ad-
ditional error in reading may be produced.
• Drop protection: 1m
• The maximum size of jaw opening: 28mm In diameter
• Battery: AAA 1.5V battery × 2
• Auto power o (adjustable): The meter will auto power o if there is no operation for 15 min.
• Dimensions: 215mm × 63.5mm × 36mm
• Weight: About 235g (including batteries)
• Altitude: 2000m
• Operating temperature and humidity: 0°C~30°C (≤80%RH), 30°C~40°C (≤75%RH), 40°C~50°C (≤45%RH)
• Storage temperature and humidity: -20°C~+60°C (≤80%RH)
• Electromagnetic compatibility: RF=1V/m, overall accuracy= specied accuracy +5% of range; RF>1VIm, no specied
calculation
To Next Page
Loading...
Need help?
General
