20
3. Installation and Removal Steps
3. Fasten the rear bracket
serows and back side
hamess, and fix the unit well.
Remooac, inset key into the set then pull
the set out trow dash board.
3.2 Dismantling
Insert the dismantling key into the key hole of device until the hook lock is open, then get the device
and key out.
Remark:
1. Don’t install the device in the place of impeding driving or may hurt
passenger by emergency brake.
2. In order to install the device properly, please use our accessories
only, or else it may cause unnecessary damages. If it needs to drill or
have any necessary changes during the installation process, please
contact with the nearby dealer.
To Next Page
Loading...