Multimetrix CM600 - Page 13

12
4. MAINTENANCE
4.1 METROLOGICAL CHECKS
As with any measuring or testing instrument, periodic checking
is required. Information and contact details are available on
request or contact your distributor.
4.2 SERVICING
Periodically clean your multimeter with a cloth dampened with
soapy water. Do not use abrasives or solvents.
4.3 REPAIRS OUTSIDE METROPOLITAN FRANCE.
For any work under or outside the guarantee, the instrument
must be returned to the distributor.
5. STORAGE
Remove the batteries and store them separately if you
measuring instrument has not been used for more than 60
days.
USE
6. INTRODUCTION
6.1 THE FRONT FACE
No.
Function
1.
Black negative COM terminal (-)
2.
Liquid crystal display:
- CM600 / CM610: 3 ½ digits (1999 points)
- CM625: 4 digits (4369 points)
‘----‘: current and voltage measurements exceed the
range
3.
Function rotary selector switch
OFF : Multimeter off
: AC current (CM600 and CM610: 600 A and
CM625: 400 A)
: DC current
(only on CM625: 400 A)
: AC voltage on CM600, CM610
and CM625 (600 V)
: DC voltage on CM600, CM610 and CM625
(600 V)
: Resistance (only on CM600 and CM610: 20
MΩ)
: Resistance and continuity
(only on CM625: 40 MΩ)
: Diode and continuity test
(only on CM600 and CM610)
4.
Trigger for opening the clamp
5.
When measuring, your hand must always be behind
this protective guard.