Multiplex PROFI CAR 403 - Selecting the Model Type 2+5 CH (Truck); Setting the Control Mode for the Auxiliary Channels

40
§ Control mode „3ST“ (3 stages)
In this mode the servo switches between centre and one end-point when
you briefly press the same side of the associated rocker. If you press the
other side of the rocker briefly, the servo switches immediately to the
opposite end-point. The digi-adjustor controls servo 6 in a similar way.
We recommend that you simply try out the different control modes with a servo.
Special case: channel 7 is controlled by the handle button
G
.
Channel 7 can only be used in the control mode „2ST“ (2 stages). When you press the
handle button, servo 7 runs to its second position, and stays there until you release
the button. The position of servo 7 is not shown on the screen.
You can adjust both servo positions in the menu point „S-TRAV“
of the menu T (see 8.3).
8.1. Selecting the model type 2+5 CH (truck)
If you just want to experiment with this option for a while, switch to a vacant model
memory (menu point „GO TO“).
§ Search for the menu point „TYPE“ using the T button.
§ Select „2+5 CH“ using the digi-adjustor.
• Hold the handle button
G
pressed in for longer than 3 seconds to confirm your
selection.
Press any menu button (except T ) to return to the operating display.
!!
If you use the vehicle type „2+5 CH“ (TRUCK), no timer functions are available,
although you can still check the transmitter’s operating time.
8.2. Setting the control mode for the auxiliary channels
(menu point „S-NORM“)
The control modes for the auxiliary channels are located in the same part of the
menu where you set the signal format and direction of servo rotation.
§ Search for the menu point „S-NORM“ using the T button.
§ Search for the servo you wish to adjust using the handle button
G
.
§ Use the digi-adjustor to select one of the control modes PRoportional,
FLashing or 3STages.
Press any menu button (except T ) to return to the operating display.