EasyManua.ls Logo

Multiplex Royal SX 16 User Manual

Multiplex Royal SX 16
113 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • Bretten • Germany
© MULTIPLEX 2014 • Printed in Germany
www.multiplex-rc.de
Instructions

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Multiplex Royal SX 16 and is the answer not in the manual?

Multiplex Royal SX 16 Specifications

General IconGeneral
Channels16
TelemetryYes
ModulationFHSS
Frequency Band2.4 GHz
Model Memory200
Battery4000 mAh LiFe

Summary

Safety Notes

General safety notes

Provides essential guidelines for safe model building, operation, and handling of RC equipment to prevent damage or injury.

Range checking

Explains the importance and procedure for performing regular range checks to ensure reliable radio control operation.

The Transmitter Battery

Charging the transmitter battery

Details the correct procedure and precautions for charging the PERMABATT+ battery, including fast-charging.

Switching on, using the transmitter

Range Checking

Provides instructions for performing a range check, crucial for ensuring safe operation before flying.

The “ROYAL SX” philosophy

What do the sticks, sliders and switches do? Or: Global assignments (lists)

Details how transmitter controls (sticks, sliders, switches) are assigned to model functions using global lists.

Model templates

Explains the purpose and use of pre-defined model templates to simplify new model setup.

Servo calibration

Covers the process of calibrating servos to ensure accurate control surface travel and matching.

Setting up a fixed-wing model

Setting up the new model in the transmitter

Step-by-step guide for creating a new model memory, including template, servo config, and stick mode selection.

Preparing servos

Details the process of assigning servos to receiver outputs, checking directions, and calibrating their movements.

Working with flight phases

Explains how to use flight phases to adjust transmitter control settings for different flight situations.

Setting up a model helicopter

Setting up a New model in the transmitter

Guides users through creating a new helicopter model memory, covering template, servo config, and stick mode.

Checking / changing the servo Assignment

Covers assigning servos to receiver outputs and changing servo signal format or calibration points.

Checking / adjusting the main rotor

Describes the process of calibrating main rotor servos for correct centre position and travel.

Gyro

Explains how to configure and adjust gyro settings (Heading or Damping mode) for helicopter stabilization.

Working with Flight phases

Details how to utilize flight phases for helicopter-specific adjustments like collective pitch and throttle curves.

Main menu Setup

Main menu Control

Main menu Mixer

Main menu Servo

Main menu Memo

Setting up a New model

Provides the final steps for setting up a new model, including confirming parameters and switching to the new memory.

Special facilities

Using the 3-D digi-adjuster to alter settings in flight

Explains how to assign parameters to 3-D digi-adjusters for real-time adjustments during flight.

Model templates in detail

Related product manuals