ROYAL SX
92
b. Using the stick switches
The switch connected to the terminal clamps ABC
must first be assigned to the switch KSw using the
transmitter’s software. This is the procedure:
Main menu: ¡Setup
Menu: Assignment
Menu point: Switches
Parameter: Extra Sw.
Extra Sw. -> KSw
!
This applies to all assignment lists!
c. Connecting the stick button
The stick button in the aluminium stick top must be
connected to the screw-clamps CD:
Stick button connections
The stick button must be entered as KTa at the appro-
priate point in the menu Assignment, Controls /
Switches.
Example: using the button to activate the primary
flight phase
If you wish to activate the primary (flight) phase when
the button is pressed in, use this procedure:
Main menu: ¡Setup
Menu: Assignment
Sub-menu: Switches
Parameter: Open Main phase
Confirm the warning message by pressing ENTER.
Press and hold the stick button.
Conclude the assignment by pressing ENTER.
The Main phase line in the menu must now look like
this:
Main phase KTa #*
The asterisk “*” at the end of the line will be displayed
as long as you hold the button pressed in.
d. Connecting a stick switch or second stick button
The stick switch in the aluminium stick top must be
connected to the clamps ABC (see picture below).
Alternatively a second stick top with button can be
connected instead of the switch. In this case you must
use terminal clamps B and C. The following illustration
shows the method of connecting a switch or push-
button:
Extra switch connections switch or push-button
This also determines the name by which the switch is
addressed in the transmitter software. The Extra
Switch can be used as a transmitter control (e.g. re-
tract switch, spoilers, …) or as a simple switch (e.g.
flight phases, …).
!
The Extra Switch has priority!
The Extra Switch has priority over the physical con-
trols P, K and the stick switch KSw ( 9.5.). The con-
trol element installed in the transmitter for the Extra
Switch can be left in the transmitter, but the software
ignores it.
Example: 2-position switch for retracts
Once the switch is installed and connected to the ABC
terminals, the procedure is as follows:
1. Assigning the Extra switch
Main menu: ¡Setup
Menu: Assignment
Sub-menu: Switches
Parameter: Extra Sw.
Open by pressing ENTER, confirm the warning
message, then select KSw.:
Extra Sw. -> KSw
Confirm with ENTER.
2. Assigning a control for retracts (landing gear)
Main menu: ¡Setup
Menu: Assignment
Sub-menu: Controls (not Switches!)
Parameter: L. gear
Open by pressing ENTER, confirm the warning
message, then move the stick switch
(Quick-Select):
L. gear KSw #*
and confirm with ENTER.
To Next Page
Loading...
