Multiplex Royal SX 16 - The ROYAL SX Philosophy; Using the Keypad; Operating the ROYAL SX; Status Display 3 (Timers)

Manual
25
1
2
3
4
5
Bars
Line 1
Status of the 3-D digi-adjusters ( Status display 1)
Line 2
Current model memory ( Status display 1)
Line 3
Actual battery voltage ( Status display 1)
Line 4
Switch used to select the current flight phase ( 19.4.)
Line 5
Current flight phase with number and name: 1:NORMAL
Bars
Current trim positions ( Status display 1)
10.8.3. Status display 3 (timers)
The screen only displays those timers to which a
switch has been assigned. After the timer the screen
shows the associated switch (in this example: the Slot
timer is controlled using switch “P”):
1
2
3
4
5
Bars
Line 1
Status of the 3-D digi-adjusters ( Status display 1)
Line 2
Direction of operation of each timer (here: counting
down)
Line 3
Slot timer ( 18.3.)
Line 4
Sum timer ( 18.4.)
Line 5
Interval timer ( 18.5.)
Bars
Current trim positions ( Status display 1)
10.8.4. Status display 4 (system information)
1
2
3
4
5
Line 1
Transmitter type: ROYAL SX 9 or 16
Software version: e.g. 3.46,
Loaded language set:
e.g. DE/EN (German / English)
Line 2
Actual battery voltage
Line 3
Available battery charge quantity
Line 4
Calculated remaining transmitter operating time
based on the available battery charge quantity and
the actual current drain. Only displayed if an RF sig-
nal is being transmitted.
The red LED must flash!
Line 5
Transmitter operating time, up to 1000.0 hours,
then restarts at 0.0 h
11. The “ROYAL SX” philosophy
11.1. Operating the ROYAL SX
11.1.1. Using the keypad
The ROYAL SX is programmed using the keypad and
the two 3-D digi-adjusters. There are eleven buttons in
all.
a. Six buttons for direct access to main menus
L
Setup (Configuration)
H
Control
G
Mixer
K
Servo
A
Timer
I
Memory
b. Special function buttons
F
Allocate 3-D digi-adjuster for:
altering values in flight  20.1.
calibrating servos  17.1.2.
Activate scanner when switching on
REV/CLR
Reverse (REVerse) Erase (CLeaR).
Many set-up values (% values) can be restored to
the default setting using this button
ENTER
Menu / Open / Close parameter

Cursor up / Increase values

Cursor down / Reduce values
c. Text input buttons
The ten buttons with inscribed letters are used for en-
tering text (name of transmitter owner, model, free
mixers, assignment lists):
Text is entered in the manner familiar from mobile
telephones. The two 3-D digi-adjusters can be used to
select individual characters in the input field.
The characters which can be called up by rapidly and
repeatedly pressing one button are printed in small
script below the direct menu access buttons (row 1)
and above the working buttons (row 2).
ROYAL SX16 3.46 DE/EN
M-LINK
Batt. voltage 8.20V
Battery charge 1998mAh
Remaining time 7.7h
Operating time 12.4h