MULTISPAN PID 4201-1C User Manual

Press key to
save & exit
ENT
Press key to
save & exit
ENT
SET
Set Point
Password Message
Press key for 4 sec to
enter Password
SET
SET
ENT
Process Value
Password Message
Press key
ENT
TO ENTER BASIC
CONFIGURATION
SETTING, ENTER “73”
Basic Configuration
Set Point Setting
Set Value
Control Parameter
TO ENTER CONTROL
PARAMETER
SETTING, ENTER “37”
(If R1MD = PID)
1) Press key to go parameter setting.
SET
3) Press key to save change in setting
4) Press key for 6 sec to start/stop PID AUTO TUNING
5) Press + key for 3 sec to go to factory setting mode.
2) Press or key to change value or to select option.
Key Operation
SET
Factory Setting
ENT
ENT
yes : press key to apply factory set
values as shown in table.
nO : press key to escape
from factory setting.
Select on/off value & press key
to turn on/off heater
Press + key
for 3 sec
Press + key for
4 sec for Heater on/off
FACTORY SETTING
PARAMETER
IT
CT
MR
HYSTERESIS
PB
DT
VALUES
300
15 SEC.
20.0
75
0°C
3°0
SR.
2
4
OFFSET
6
1
3
5
7
0°C
PIDAUTO-TUNING
Presskeyfor6sectostart/stop
PIDauto-tuning
C
PV
R
Current
°
Page-2
PID-4201-1C
www.multispanindia.com
(0.0 to 30.0)
Press key
ENT
(-20 to 20)

MULTISPAN PID 4201-1C Specifications

General

Brand	MULTISPAN
Model	PID 4201-1C
Category	Controller
Language	English