Multitech MultiConnect rCell 100 Series Hardware Guide

INSTALLING THE ROUTER
MultiConnect
®
rCell 100 MTR-LTE Hardware Guide 25
2. Push the SIM card into the slot until it snaps into place.
3. To remove the SIM, push the edge of the card in. When released, the card pops out of the device.
Resetting the Device
You need:
A pin, paperclip, or similar thin object that can fit into the reset hole
The following is the default condition for the RESET button on the device. You can program a change to the
behavior of the button if needed.
To reset the device:
1. Find the hole labeled RESET. The reset button is recessed into the case.
2. Use the pin to press and release the RESET button as follows:
Reset options:
To reboot, press RESET for less than 3 seconds.
To reboot and restore user-defined defaults (if previously set), press RESET for 3 to 29
seconds.
To reboot, restore factory settings, and erase user-defined defaults, press RESET for 30
seconds or longer.
The device restarts in commissioning mode. The system automatically removes all user
accounts.
Enter a new username and password to create your new administrative account. (Refer to
User Accounts in the appropriate software guide for details on username and password
requirements.)
Note: The device reboots when restoring settings.
Restoring User Defined Settings to the Device
You can restore user defined settings to your device.

Multitech MultiConnect rCell 100 Series Specifications

General

Brand	Multitech
Model	MultiConnect rCell 100 Series
Category	Network Router
Language	English