4 AT Commands, S-Registers, and Result Codes
38
Command: :E
n
MNP10 Compromise Equalizer Enable
Values: n = 0 or 1
Default: n/a
Description: This command is included only for compatibility and performs
no function.
:E0–:E1 n/a
Command: $SB
n
Serial Port Baud Rate
Values: n = speed in bits per second
Default: 57600
Description: $SB300 Set serial port to 300 bps.
$SB1200 Set serial port to 1200 bps.
$SB2400 Set serial port to 2400 bps.
$SB4800 Set serial port to 4800 bps.
$SB9600 Set serial port to 9600 bps.
$SB19200 Set serial port to 19200 bps.
$SB38400 Set serial port to 38400 bps.
$SB57600 Set serial port to 57600 bps.
$SB115200 Set serial port to 115200 bps.
$SB230400 Set serial port to 230400 bps.
Note: See also the L5 command.
To Next Page
Loading...
