RPR 550IS Series
TM1188 Issue 1 Page 5 - 3
ROUTINE MAINTENANCE
1. Routine maintenance is limited to battery replacement and surface cleaning of the
pager, using a lint-free cloth moistened with soapy water.
SERVICE POLICY
Important
MAINTENANCE AND REPAIRS TO THIS EQUIPMENT MAY ONLY BE CARRIED OUT
BY MULTITONE AUTHORISED PERSONNEL. LIABILITY IS NOT ACCEPTED FOR
WORK CARRIED OUT BY OTHER THIRD PARTIES.
2. Repairs are only to be performed by qualified personnel in authorised workshops.
3. Pagers in the RPR 550IS Series are repairable to component level. The display is to
be treated as a disposable module. Any screening cans, which are removed in order
to access components, must be refitted flush to the board.
4. With reference to Section 7, Figures 13 and 14; If components are replaced in the areas
marked A and B, then apply two coats of lacquer to the main board to the minimum area
shown. Area A, coat side 1 only. Area B, coat side 1 and side 2.
5. If wire links are replaced refer to Section 7, Figures 13 and 14 for details of sleeving
and wire lengths.
WORKSHOP PROVISIONS
6. Repair workshops must be free from hostile radio interference or otherwise equipped
with Faraday cages. Suitable equipment must be available to remove and replace the
surface mount components which are extensively used in this pager.
CAUTION
STATIC SENSITIVE DEVICES ARE USED WITHIN THIS EQUIPMENT. CARE MUST
BE TAKEN TO ENSURE DAMAGE TO THESE DEVICES IS NOT CAUSED BY HIGH
LEVELS OF STATIC ELECTRICITY.
To Next Page
Loading...