RPR 550IS Series
TM1188 Issue 1 AL2 (Oct. 98)Page (vi)
ANY COMPONENT MARKED THUS i ON CIRCUIT DIAGRAMS MAY ONLY BE
REPLACED BY ANOTHER OF AN IDENTICAL TYPE AND SPECIFICATION. THE
LEAD LENGTH AND LOCATION MUST BE IDENTICAL TO THAT OF THE
ORIGINAL COMPONENT.
THE FOLLOWING PRECAUTIONS MUST BE OBSERVED WHEN CHARGING OR
REPLACING THE BATTERY.
SAFETY SUMMARY
The following information applies to both operating and servicing personnel. General
Warnings and Cautions will be found throughout the manual where they apply.
WARNING statements identify conditions or practices that could result in injury or loss of life.
CAUTION statements identify conditions or practices that could result in equipment damage.
WARNINGS
1. DO NOT attempt to replace or charge a battery in a hazardous area
where explosive gases may be present.
2. Only the battery types listed on the equipment label and in the User
Guide may be used with RPR 550IS series pagers.
3. Only Absence and Charging Racks A3RO and A3RP are to be used
with RPR 550IS pagers. When Charging is enabled on these racks,
only pagers with rechargeable batteries should be inserted into the
Charging Rack pockets.
4. Always ensure that the battery door is secured before use.
To Next Page
Loading...
