To operate the Munters Drive Off/Variable with a 10-0V Signel, slide the ‘ON’ switch, located on the circuit
board in the junction box, away from the ON position. Now wire an ‘ON’ command from the ‘COMMON’
terminal to the input relay in the control and from the output of the control relay to the ‘RUN’ terminal in the
juction box. Also, connect wires from the ‘0-10V IN’ and ‘0-10V COMMON’ terminals in the junction box to
the 10-0V output in the control. See Figure 9E.
Figure 9E
Off/Variable Speed Operation
Junction Box
Control
Relay
Box
10-0V
Output
In Control
‘ON’ Switch
WARNING: Fan is designed to be operated with shutter in place. Do not apply power to fan without
shutter being installed.
Electrical WiringChapter 3
To Next Page
Loading...
