00-02-0605 - 23 - Rev 09-10-08
Utilities Menu
The following steps take place starting at the UTILITIES
menu option.
1. GAGE DATA - View information for optional connected
PVA gages.
2. REMOVE ALL GAGES - Reset the PowerView's gage
memory.
3. SOFTWARE VERSION - View the PowerView's
software version.
4. MODBUS SETUP – refer to ‘Modbus Setup’ section.
5. FAULT CODE CONVERSION - View/edit the J1939
fault code conversion method.
NOTE: There are four (4) different methods for
converting fault codes. The PowerView always looks for
J1939 Version 4 and can be set to read the code as
one of three (3) other J1939 versions if Version 4 is not
To Next Page
Loading...
