Murray 42583X9A - How to Change the Mdlcher Plate; This Murray, Inc. Two (2) Year Limited Warranty Is Your Exclusive Remedy; However, this Warranty Is Void or Does Not App|Y

OPERATION
HOW TO CHANGE THE MULCHER PLATE
A WARNING: To prevent the engine from starting, dis-
connect the wire from the spark plug. Make sure the
blade rotation control is in the DISENGAGE position.
The mulcher plate lets you mulch the grass for a clean, fine cut. To
discharge the grass out the side or intoa grass bagger, remove the
rnulcher plate as follows.
How To Remove The Mulcher Plate
1. Raise the deflector. Remove the two wingnuts B and two car-
riage bolts A (Figure t2).
2. Liftthe mulcher plate away from the mower housing.
3. Attach wingnuts B and carriage bolts A to the mulcher plate
for future use.
How To Install The Mulcher Plate
1. Raise the deflector. Slide the front of the mulcher plate under
the deflector bracket (Figure 12). Ifnecessary, remove grass
fTom flange.
2. Fasten the mulcher plate with two wingnuts and two carriage
bolts.
DeflectorBracket
Mulche_Plate
B
Deflector
B Figure 12
F- 98889 19