MAINTENANCE
MAINTENANCE CHART
PROCEDURE
FIRST EVERY EVERY EVERY
EACH 2 2S 50 100
USE HOURS HOURS HOURS HOURS
BEFORE
STORAGE
M
O
W
E
R
Blade Rotation Control, Check
Motion Drive Belt, Check
Battery, Check and Charge
¢
¢
Lubrication _/
¢
¢
GENERAL RECOMMENDATIONS
1. The owner's responsibility isto maintain this product. This will
extend the life of the product and is also necessary to maintain
warranty coverage.
2. Check the spark plug, drive brake, lubricate the unit,and clean
the air filter once a year.
3. Check the fasteners. Make sure all fasteners are tight.
4. Followthe Maintenance section tokeep the unit ingood operat-
ing condition.
WARNING: Before you make an Inspection, adjust-
A ment, or repair to the unit, disconnect the wire to the
spark plug. Remove the wire from the spark plug to
prevent the engine from starting by accident.
NOTE: Torque Is measured in foot pounds (metric Nm). This
measurement describes how tight a nut or bolt must be. The
torque is measured with a torque wrench.
HOW TO CHECK THE MUFFLER
Check the mufflerevery 50 hours. Make sure the muffler iscorrectly
mounted and is not loose. Ifthe muffleris worn orburnt, replace with
a new muffler. A worn muffler is a fire hazard and can also damage
the engine.
If you mount a spark arrester to the muffler, also check the spark
arrester when you check the muffler. Ifthe spark arrester is worn or
damaged, replace it with a new spark arrester. See your nearest
authorized service center for a spark arrester.
F- 98889 20
To Next Page
Loading...
