MAINTENANCE
M
O
W
E
R
MAINTENANCECHART
PROCEDURE
Blade Rotation Control, Check
Motion Drive Bait, Check
Battery, Check and Charge
Lubrication
EACH
USE
RRST
2
HOURS
EVERY
25
HOURS
¢
¢
¢
EVERY
50
HOURS
EVERY
100
HOURS
BEFORE
STORAGE
GENERAL RECOMMENDATIONS
1. The owner's responsibility isto maintain this product. This will
extend the life of the product and is also necessary to maintain
warranty coverage.
2. Check the spark plug, drive brake, lubricate the unit, and clean
the airfilter once a year.
3. Check the fasteners. Make sure all fasteners are tight.
4. Followthe Maintenance section to keep the unitingood operat-
ing condition.
A
WARNING: Before you make an inspection, adjust-
ment, or repair to the unit, disconnect the wire to the
spark plug. Remove the wire from the spark plug to
prevent the engine from starting by accident.
NOTE: Torque is measured in foot pounds (metric Nm). This
measurement describes how tight a nut or bolt must be. The
torque is measured with a torque wrench.
HOW TO CHECK THE MUFFLER
Check the mufflerevery 50 hours. Make sure the muffleris correctly
mounted and is not loose. Ifthe mufflerisworn orburnt,replace with
a now muffler.Aworn muffler isa fire hazard and can also damage
the engine.
If you mount a spark arrester to the muffler, also check the spark
arrester when you check the muffler. Ifthe spark an'ester isworn or
damaged, replace it with a new spark arrester. See your nearest
authorized service center for a spark arrester,
F- 98891 20
To Next Page
Loading...
