Muse ARTisan - Wi-Fi Connection (LXi Software)

8.
9.
A menu of available networks will appear. Select the network used for the ARTisan setup and, if needed,
enter the network password. Wait a bit for the connection to be made and the menu should indicate you
are now connected to that network.
Proceed to either the next section (if using LXi Production Manager) or Section 1.9.5 (if using Create Space).
Click Next. You will be asked how your ARTisan is connected to the computer. Select TCP/IP. A small
window will appear in which you can type in the cutter’s IP Address from Step 5 in Section 1.9.3
On a PC:
On a Mac:
Click on the Network icon.
(usually in lower right corner)
Click on the Network icon.
(usually in upper right corner)
If you are connected via
Ethernet, your network icon
may look like this.
Wi-Fi Connection in LXi
1.9.4
Open LXi Production Manager. If this is your first time opening LXi, a pop-up screen will request a Brand
and Model selection. Otherwise, select Setup and from the drop-down menu, click Add Setup.
From the pop-up window, choose MUSE as the Brand. Find and select ARTISAN in the Model window:
Below TCP/ IP address, you will need to enter
the correct Port number which is 8080. Enter
this value and click Test. If you have a
successful connection, LXi will indicate
success. Click on OK to close the
Communication window. Click on Finish at the
bottom of the Add Setup window.
If Test fails, check the ARTisan again to verify
the network name and the IP address. If you
change settings, it may be necessary to wait a
minute and start from the beginning of the
process in order to allow the computer time
to reset and recognize the Wi-Fi connection.