Muse ARTisan - Wi-Fi Connection (Create Space)

Wi-Fi Connection in Create Space
1.9.5
Open Create Space and select New Project.
Go to Cutter>My Cutter>Manage Cutters.
A new window will open. On the right side, under Company/Brand select MUSE and under Model
select ARTisan. Click Add to list. Click Done to apply and close the window:
Once you are ready to cut, click the
Cutter icon on the Toolbar at the top of
the screen. The Cut Settings window will
open and, in the Connection drop-down
menu, select TCP/IP
In the IP field, type in the IP Address from
Step 5 in Section 1.9.3.
Once you type in the IP address, click on
Test Connection, it will move the blade
carriage back and forth. This does not
send a cut, just a signal to the cutter. If
not connected, check the ARTisan again
to verify the network name and the IP
address. If you change settings, it may be
necessary to wait a minute and start from
the beginning of the process in order to
allow the computer time to reset and
USB Flash Drive Setup in LXi
1.9.6
If you are new to LXi, follow the first few steps in Section 1.9.1 to add the Muse to LXi Production
Manager.
Using the UDISK (USB thumb drive) option involves saving a .PLT file containing the cut design and
some or all of the cut settings. This file can then be opened directly onto the ARTisan and cut.
Remember that with this option, once the file is saved to the thumb drive, the design is locked in and
cannot be edited.
Once your file is ready to cut in LXi, insert a
USB flash drive into the design station computer.
Go to File>Cut/Plot or click the Cut/Plot
icon . A window will open and you will
need to select the location of the LXi
Production Manager in relation to your
design station computer:
recognize the Wi-Fi connection.