Suspension and wheels
F
- 35 -
Connecting rod reassembly
Be careful to correctly position washers when reas-
sembling.
Apply Loctite 270 on the screw (1) that fixes the con-
necting rod to the steering head. Tighten the screw (1)
to the prescribed torque pressure.
Threadlocking product used: Loctite 270
Torque pressure: 8 ÷ 10 N·m
1
8÷10 N•m
Remove the screw (3) that connects the connecting
rod to the steering shock absorber.
Check that the connecting rod is in good condition and
that play is not present on the two bearings.
If play is found, substitute the worn parts with new
ones.
2
Use strong 270 Loctite thread-brakes on the screws (3)
that fix the linkage to the steering shock absorber.
Tighten the screw to the prescribed torque pressure.
Threadlocking product used: Loctite 270
Torque pressure: 8 ÷ 10 N·m
8÷10 N•m
3
To Next Page