At the start of the ironing job or when filling the tank with water, you must
press and hold the steam button 6 ( ) until steam comes out of the holes
in the iron. It is normal for a vibration noise to sound in the main unit, this
sound is caused by the air into the pump and will disappear a few seconds.
If during the steam ironing work you need to press button 6 ( ) for as long
as you think appropriate, during this time you will be doing steam ironing.
Remember that the steam flow depends on the steam flow regulator 13.
After ironing, turn off the ironing center by means of the main switch and
turn the temperature selector 7 to the position marked "MIN", then unplug
the ironing center from the mains socket and wait for it to cool down
completely before moving or manipulating it.
Before emptying the ironing center, empty the water tank 1 completely.
To transport the ironing center, use the folding handle 2, to extract or
collect it, see the corresponding section.
Notes:
The ironing center automatically adjusts the steam control according to
the chosen temperature, with the low temperature "SYNTHETIC" for
synthetic fabrics, acrylics, etc. there will be no steam outlet.
During the ironing operation, the temperature indicator light 5 will turn on
and off alternately. This is normal and means that the thermostat is
perfectly controlling the temperature of the sole plate.
NEVER bend or twist the hose 8, the water from the water tank circulates
inside it.
Very important¡
At the beginning of the work of ironing or when filling the tank with water, it is
normal that when the steam is used, a vibration noise is heard in the main
unit. This sound is produced by the entry of air into the pump and will
disappear within a few seconds of use.
DRY IRONING
Check that the water tank 1 is empty, the anti-lime filter 3 is correctly fitted
in its housing and that the handle 2 is collected.
Plug the ironing center into a mains power socket
To turn on the iron press the main switch 14, the water tank will light
indicating that the ironing center is on.
Turn the temperature selector 7 to the position marked "SYNTHETIC",
"WOOL SILK", " COTTON" or "MAX ", depending on the type
of garment to be ironed, see the ironing guide in this manual.
The temperature indicator light 5 will light up until the temperature of the
sole of the iron reaches the selected temperature.
To Next Page
Loading...