- 23 -
must cross any of these, do so at 90-degree
angles.
III. Connect the boundary wire to the Fence
Transmitter: Strip the ends of the Boundary
Wire and Insert each into the Boundary Wire
Terminals of Fence Transmitter to make a
complete loop. Plug the Power Adaptor into
the Power Jack of the Fence Transmitter and
AC power supply outlet.
Important: If the Boundary Wire connection is
OK, the Loop Indicator Light will turn on after
you plug in the power supply. Otherwise, the
Fence Transmitter will beep to warn of a break
in the loop.
IV. Prepare the Receiver Collar: Your
Receiver Collar comes with short Contact
Prongs installed. Use the long Contact Prong
for pets with long or thick hair, and the short
To Next Page
Loading...