- 24 -
prong for pets with shorter coats of hair. In
some cases it may be advisable to shave dogs
neck area for Max impact of the prongs if
required. Then simply press the On/Off button
on the Receiver Collar to turn the collar on.
V. Set the boundary width and test the
Receiver Collar: Rotate the knob of the
Boundary Control Switch to adjust the width
of the Warning Zone and also the Vibrate and
Static Correction Zone. Set the Boundary
width as wide as possible to give your pet the
widest Warning Zone and Correction Zone
possible.
To test the Receiver Collar, make sure the
collar is first powered on. Hold the Receiver
Collar at your pet’s neck level and walk toward
the Boundary Wire with Contact Prong
pointing up until the Receiver Collar beeps.
If the Receiver Collar does not beep at the
To Next Page
Loading...